Description

Features：

1. Good molding, low odor and low shrinkage;

2. The performance of tensile, bending and toughness is relatively good, and it can be punched and tapped.

3. The molding performance is similar to PA, and it is applied to product models that require high hardness and high toughness, such as the production of structural models, and products that require better material properties

Notes:

1. Shake well before use. It is recommended to stand upside down three times. It is forbidden to use resin in places exposed to sunlight.

2. Do not take orally. Keep away from children. Wear gloves before use to avoid direct contact with skin and maintain indoor ventilation; Do not get into eyes. In case of accidental contact, rinse with plenty of water as soon as possible. In case of discomfort, seek medical advice in time.

3. The printed resin model needs to be cleaned with high concentration alcohol (above 95% concentration is recommended, the higher the better) for about 30s; After cleaning to dry alcohol after secondary curing, so as to get the best performance.

4. The used resin in the chute shall not be put back into the unused resin, and the resin shall not be placed in the chute for a long time(if not for a long time, the resin can be imported into the container and sealed with plastic wrap for shading preservation), so as to avoid the contamination of the resin to affect the printing effect.

5. Store it away from light at room temperature. The sun contains ultraviolet rays, which will cure the photosensitive resin; It is recommended to store it at an ambient temperature of 15-35 ℃. The lower the temperature in winter, the higher the resin viscosity.

6. Sealed and stored to avoid dust or moisture, which will affect the printing quality.

View AllClose