Kit 1 EU (No Puller)
Packing lncluded:
1x 20W Glue Gun
5x Yellow 7*270mm Glue Sticks

Kit 2 (No Glue)
Packing lncluded:
20x Blue Tabs
1x T Bar Tools

Kit 3
Packing lncluded:
20x Blue Tabs
1x T Bar Tools
2x Shovel
1x Towel
1x Alcohol Bottle(Alcohol  not included)
1x The Instruction
5x Yellow 7*270mmGlue Sticks
5x Black 7*270mmGlue Sticks
1x 20W Glue Gun(US/EU Plug)

Kit 4
20x Short Blue Tabs(5 Sizes)
4 * Long Blue Tabs (2 Sizes)
2 * holder   (2 Sizes)
1x T Bar Tools

Description:
This Paintless Dent Repair T-Bar puller is a lightweight glue tab pulling tool, meant to be used when repairing pressure dents and any dent that isn't sharp or creased.
The tension puller works well with a tap down hammer when pulling large dents.
It's very easy to control, everyone can removal the dent easily by yourself.

Features:
1. Slide hammer is more powerful for dent repair, conquer big dent.
2. The principle is making glue tabs stick on the dent and use tools pulling the tabs and lift the dent.
3. Big dent needs slide hammer or puller; small dent needs mini dent lifter or pulling bridge.
4. Different tabs for different dent lifter or the Slide hammer, works with all glue pullers.
5. Use a slide hammer or dent lifter or any pulling tools lift the dent, try many times.

How to use:
1.Clean the dent with a clean wet cloth;
2.Mount the glue stick into the glue gun, pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes;
3.Use a proper drawing gasket. Large dent requires a large drawing gasket.
4. Pull the trigger and apply the drawing gasket with extruded glue;
5. Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adheres;
6. Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent;
7. Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen;
8. Clean the repaired place with a clean wet cloth.