NanoVNA-F V2 Vector Network Analyzer New Upgraded 50KHz-3GHz Antenna Analyzer HF VHF UHF VNA 4.3" with 5000mAh- Measuring S Parameters, Voltage Standing Wave Ratio, Phase, Delay, Smith Chart

2022 Upgraded Version: The NanoVNA-F V2 has been upgraded on the basis of NanoVNA-F to lastest Firmware 0.4.0, and the operation page is compatible with Nanovna-F. It can measure S-parameter, voltage standing wave ratio SWR, phase map, group delay, Smith chart, DELAY, POLAR, LINEAR and so on
Improved Frequency Range: The NanoVNA-F V2 measurement range is 50KHz-3GHz, which is lager than the old version(previous is 10KHz-1.5GHz).The TX/RX method can measure the complete S11 and S21 parameters，S21 dynamic ranges: 70dB (1.5GHz), 60dB (3GHz); S11 dynamic ranges: 50dB (1.5GHz), 40dB (3GHz)
New Design: The Anterna analyzer uses all-aluminum alloy cases, which are sturdy and durable and can effectively shielded electtomagnetic interference to ensure measurement accuracy. The radio frequency interface is SMA, which is convenient for connecting various types of measurement
4.3 inch screen & 5000mAh Battery： This vector network analyzer has a 4.3-inch IPS TFT LCD and resistive touch screen with resolution of 800*480, an large viewing angle. It is upgraded to 5000mAh large-capacity lithium batteries has longer standby time, up to 7 hours, which can be used for a long time. Use a 2A large -current charging IC, the charging time is shorter. As an add-on, the built-in 5V output is for Android phone or tablet charging
PC & Android Phone Controlled: Using PC software NanoVNA Saver, it can connect to the NanoVNA and extracts the data for display on a computer, and for saving to Touchstone files. We can export Touchstone (snp) files for various radio design and simulation software through PC software. Supports Android Mobile Phone only

Specifications

Measuring Frequency: 50kHz ~ 3GHz

RF output: - 14 DBM (maximum - 9 dbm)

Frequency accuracy: < 0.5 ppm Port SWR: < 1.1

Number of calibration points: 201

Number of scanning points: 201

Display: 4.3 inch IPS TFT (800x480)

USB Interface: USB Type-C

Communication Mode: CDC (Serial)

Power consumption: USB 5V 200mA, 5000mAh battery

Output capability: 5V/1A, supporting Android and Apple phones