LED:

1.When electrified, LED lights 1 second, it’s ready to work.

2.LEARNING CODE:
press P1 (1 second at least), LED lights (1 second) and goes off( 1 second) and lights again, now press any
button of the remote, if the code is learnt LED will go off. Then release the button of the remote. If the remote
cannot read the signal, LED will light for 10 seconds and finish learning status.
A.press P1 one time, LED flashes one time and the first channel (monostable) activates.
B.press P1 three times, LED flashes three times and the first channel (bistable) activates.

3.PROGRAMMING METHOD:
Each channel can learn 140 codes at least.
It supports all the codes including fixed code and rolling code.

4.DELETING FUNCTION:
A.Delete one code: Press P2 for about 1 second and release, LED lights, press the button that you want to
delete the code. Then it’s ok.
B.Delete all the codes: long press P2 for 8 seconds, LED lights, release your hand and LED goes off, now all
the codes are deleted.

5.NOTICE:
A.since the data of rolling code is relatively bigger, it’ll take you a little more time to operate remote with rolling
code than that with fixed code.
B.If you learning same code for more than one time, only the last code is memorized

Description for Keypad

Warnings:

l Note that autimatic gate and door sustems must be installed exclusively by qualified

technical personnel in full compliance with statutory legislation.

l Before starting the installation procedure check that the values given in the "Technical

Specifications"chapter are compatible with the application.

l This product has been designed to control door openers, gate openers and similar