Notes before installation:

1. Prohibit installation under sunlight!
2. Make sure the phone temperature is normal and not overheated
3. Check whether the UV light is on normally after connecting to the power supply
4.12Pro/12S Pro is common with 13pro, and the screen size is 6.73inch
If there is any problem, please contact customer service

How to install

STEP 2

Wipe the screen evenly with leveling wipes

STEP 3

Wipe again with ①wet wipes

STEP 4

Dry the screen with ②dry wipes until there is no water mark

STEP 5

Remove dust from the screen with ③dust absorber

STEP 6

Install the frame from top to bottom, keep balance on all sides, make sure the frame fits your phone perfectly

STEP 7

Rotate the green alignment paddle to vertical

STEP 8

Make sure to push the bracket to the end

STEP 9

Important: The level must be balanced on all sides
(The bubble of the level is between the scale lines on both sides)

STEP 10

Glue needs to be dripped in the center of the screen

STEP 11

Rotate the blue cover for 4 turns and remove it.

STEP 12

Hold the middle of tube in your left hand, make its opening is facing down

STEP 13

Make the tube 5mm above the screen

STEP 14

Rotate the small cap of the tube, and the liquid glue will automatically flow out completely. Make the liquid glue on the screen in a circle

STEP 15

Tear off the isolation film of screen protector

STEP 16

Place the screen protector stays close to the top of the frame, the bottom of the screen is on the bracket

STEP 17

Take the handle of the bracket and move it out slowly, so that the screen protector can be put down slowly.

STEP 18

The glue will spread evenly on the whole screen.

Don't press the screen before the glue is cured!

STEP 19

If the glue is not completely covered after 2 minutes, you can press gently to assist

STEP 20

Connect the power and turn on the UV light, slide left and right until the light goes out automatically,

STEP 21

Rotate the green alignment paddle to return to level

STEP 22

Push the phone out from the bottom of the frame

STEP 23

Wipe around the screen with alcohol wet wipes in case glue spills

STEP 24

Then tear off the black sticker

STEP 25

Wipe around the screen again

STEP 26

Turn on the UV light again to illuminate the screen and both sides of the curved screen (30s each)

Finished