Description

Dear Customer:

1. Because our products belong to the special car series, please be sure to check whether the model year is the same before ordering to avoid errors.
2. Before placing an order,Please contact customer service to explain the color of the vehicle.Thank you.
3. Because the car models are different, the pictures are for reference only, please refer to the actual product.

Front and rear reversing radar system

Radar can provide real-time distance information of obstacles, making it easier for you to park

Function upgrades

1.Microwave radar
2.Buzzer prompt
3.Safety assisted guidance 4.Original car display
5.Waterproof probe
6.No broken line
7.Parking assist
8.Micro-hole installation
9.Original car style
10.Independent radar switch

Micro-hole installation

Original car color, built-in probe, high appearance effect

Partition detection Tri-color distance alarm

The front radar and the object enter the yellow state at a distance of 70CM, enter the orange state at a distance of 50CMand enter a red state at a distance of 30CM.

Brand new upgraded radar probe

Stronger anti-jamming ability, less signal data loss, real-time distance detection

Large wide-angle detection probe

All-round monitoring blind spots before and after, Front detection range 160°, Rear detection range 140°

When entering D / N gear Front radar starts auto

In D gear, when the vehicle speed is below 15 km/h, the front radar will auto start, When the speed is higher than 15 km/h Front radar automatically shuts down.

When entering R gear Rear radar starts auto

In R gear, The rear radar starts automatically + the front radar on the left and right sides, Let you park without worry.

Waterproof probe Real-time accurate prompt

Good waterproof performance, not affected by rain High temperature resistance, no false alarm.

Original car instrument and car screen display

The original car screen and the original car instrument are displayed simultaneously.

Probe color palette

For more colors, please contact customer service

Complete product display (pictures are for reference only):

1.Probes
2.Host computer
3.Power cable
4.Punch artifact
5.Wire harness
6.Scaffold
7.Adhesion promoter

Installation steps:

1. Whether the car has reserved holes, the front and rear bumpers can be removed directly if there are reserved holes.
2. If there is no reserved hole, it is necessary to measure the hole distance according to the model, and make the hole position.
3. Punch a hole in the center of the reserved hole, or punch a hole at the measurement position.
4. Use the provided hole opener to polish it smoothly.
5. Fix the probe.
6. Connect the probe socket, arrange the wires,
and restore the bumper.
7. The rear bumper is treated the same, and the radar probe is installed.