It is very distressed when there are dents in the car's surface, then you have to spend time and money to repair it. Don't you want to save time and money to repair it by yourself? Come on and try it.

Features:
Much cheaper than body shop repairs because it is no high paint material and labor costs.
Save more time and don't need wait for car dent repair in repair shop.
It is environment friendly and no chemicals or other toxic material are used in this process, paintless dent repair can insure 100% protect the original paint.
It is easy to operate, most of the dent removal can be finished in half hour.
No need to disassemble the car.

Material: Plastics+Stainless steel(not full metal)

【Kit 1-76Pcs】
Package included:
12x Red Tabs
28x Blue Tabs
1x Gold Puller
2x Shovel
1x Glue Gun(US/EU Plug,20W)
5x White Glue Sticker(7*270mm)
5x Yellow Glue Sticks(7*270mm)
1x Towel
1x Alcohol Bottle(Alcohol  not included)
1x Hammer
10x Knocking pen
1x Tools bag
1x The Instruction
7 x Pulling bridge set

【Kit 2-58Pcs】
Package included:
12x Red Tabs
28x Blue Tabs
1x Gold Puller
2x Shovel
1x Glue Gun(US/EU Plug,20W)
5x White Glue Sticker(7*270mm)
5x Yellow Glue Sticks(7*270mm)
1x Towel
1x Alcohol Bottle(Alcohol  not included)
1x Tools bag
1x The Instruction

【Kit 3】
Package included:
20x Blue Tabs
1x Gold Puller
2x Shovel
1x Towel
1x The Instruction

How to use the tools ?
1. Clean damage surface with a clean wet cloth;
2. Put the glue stick to gun and connect the power source and preheat for 5-10 minutes;
3. Pull the trigger and apply the suitable drawing gasket with extruded glue (The 4 holes of gasket should be applied with hot melt glue);)(Note: The larger the drawing gasket is, the larger the drawing force is);
4. Immediately place the drawing gasket with hot melt glue in the center of the dent and hold until sticks (Let the glue cool for about 5-8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter);
5. Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent;
6. When dent was removal, clear the glue by alcohol with plastic shovel;
7. If dent still exists, knock it slightly with a flattening hammer with Tapdown head 
8.Repeat the operation steps above until the dents are repaired.