Specification:

• Scale: 1:14

• Length: 515mm

• Width: 222mm

• Height: 240mm

• Deadweight: 13kg

• 10 channel 2.4Ghz radio

• New strong cylinder

•3d printing simulation seats, armrest boxes, file handles, chimneys, etc

•Brushless walking motor system

• New Metal molded tracks (50mm width)

• Reliable hydraulic valve and adjustable pump

•Pressure gauge visible

• Powder coated in yellow

• Run time is: 50 minutes (5000mAh battery)

•Lifting force: 15kg/33pounds

Quick Start Guide:

Steps for the first boot up of RTR version  

First, open the engine cover of the machine. Then find the Add oil tube." Fill 50-60ml into the tank with a syringe. After filling, remember not to block the oil pipe, or it will lead to oil spill of the oil pump motor.

Too much oil will cause oil leakage!

The remote control is loaded with 4 no. 5 dry batteries, the remote control transmitter is turned on, Place the remote control rocker in the lowest position.and then the excavator battery is connected. For excavator battery, please use 11.1v DC/DC lithium battery.

Installation of decoration parts, please refer to the finished picture.

Machine maintenance and maintenance.

1.Maintenance: the product continuously works 10 hours, must replace hydraulic oil!

2.The first time you start the pump, the oil cylinder reacts slowly, or intermittently, as a normal phenomenon. Because there is air in the cylinder pipe, it will be automatically emptied for a period of time.

3.The first time you start the pump, the oil cylinder reacts slowly, or intermittently, as a normal phenomenon. Because there is air in the cylinder pipe, it will be automatically emptied for a period of time.

4.The main engine design USES the power of 3s lithium battery 11.1v, and the input voltage is strictly prohibited to exceed 12v.

5.The chassis is electrically driven, the motor is not allowed to water, otherwise the machine will be paralyzed.